Lesson 8 · 1:35
Sketch
Add the manufactured home's sketch: answer Sketch or Floor Plan Provided, pick the measurement standard, and drag the sketch and dimensions in from Files.
Transcript
Sketch
The Sketch section holds a sketch or floor plan of the dwelling, and the standard it was measured to. Open it from the section list.
We have one
Sketch or Floor Plan Provided is the one question that's always required. We drew a sketch from the inspection measurements, so answer Yes, and two more fields appear. Measurement Standard is how the areas were measured: ANSI, AMS, or Other, for example when state law requires a different standard. We measured to ANSI, so choose ANSI. Any ANSI declarations the measurements need go in Sketch Commentary. We don't have any, so it stays empty.
From the Files panel
The sketch goes in this gallery. It's already in the report's files, so open Files from the right-hand rail. Search for the sketch, and drag it from the panel onto the gallery. The type tells the report how to caption the image: Sketch, or Floor Plan. Ours is a drawn sketch with its area calculations, so Sketch is right. The home is one level, 66 by 27 feet: 1,782 square feet of living area. The open porch, the deck and the two sheds are drawn too, outside the living area. We also wrote down the measurements at the inspection. Add that dimensions list to the same gallery. Its total, 1,782 square feet, agrees with the sketch.
Dwelling Exterior
That completes the Sketch section. Next, Dwelling Exterior.