Lesson 16 · 1:20

Inspection Photos

Place the inspection photos from the Files panel into the report: the front and rear of the building and the street scene, and where each unit's room photos go.

Watch this lesson in DataMasterSign in to your DataMaster account to watchInspection Photos — UAD 3.6 Multi-Family Report

Transcript

Inspection Photos

We uploaded the inspection photos to the Files panel when we set up the assignment. Now we place them in the report: each photo goes in the section it supports. Open Files from the right-hand rail. Show just the photos, and switch to the grid so we can see them.

Front and rear

Start with the photo every report needs: the Dwelling Front. Open Dwelling Exterior, down to its exhibits. Drag the front photo from the panel onto the Dwelling Front slot. Dwelling Exterior was only waiting on that photo, so the section is now complete. Next, the rear of the building, with its back stairs. Drop it in beside the front, and set its type to Dwelling Rear.

The street scene

In Site, Property Access needs a street scene photo. Drop the street photo into its slot, and Site is complete too.

Room photos

Room photos go in Unit Interior, in each unit's Level and Room Detail: select a room in the rail, and drop its photo into the room's gallery. Every kitchen and every bathroom needs one, in each of the four units. This assignment came with exterior photos only, so we'll leave the room galleries for now, and see what that means when we clear the errors.

Highest and Best Use

The exterior photos are in place. Next, Highest and Best Use.