Lesson 13 · 3:47
Unit Interior: Setting Up the Units
Split the listing's single unit into four in Manage Structures, then complete unit 1: area, occupancy and metering, rooms, kitchen and bath, and quality and condition.
Transcript
Unit Interior
Unit Interior describes the inside of each living unit: its area, occupancy, levels and rooms, the kitchen and baths, interior features, and the interior quality and condition. On a 2-4 unit property, every unit gets its own Unit Interior. Open it from the section list.
Four units, not one
Right now there's a single unit: the listing's whole building, with four bedrooms and 3,978 square feet. First, set up the real units. Open Structures, on the left-hand rail. Manage Structures shows the dwelling and its units. Dwelling 1 has one unit. Select Add Unit three times, for units 2, 3 and 4. Each one is marked Unit, not ADU: all four are primary living units. Close the dialog. The section list now has a Unit Interior for each unit, under Dwelling 1. Start with unit 1.
Unit 1's area
Finished Above Grade still holds the whole building's area. Each unit is 636 square feet, from the sketch, so enter 636. Every row of the area breakdown is required, even when it's zero. Unit 1 has no nonstandard area and no finished basement, so enter zero in those rows. The building's unfinished basement, about 1,270 square feet, is reported once, with unit 1, as Unfinished Below Grade. Area Data Source: we measured the building ourselves, so Physical Measurement.
Occupancy and utilities
Occupancy is as of the inspection. A tenant lives in unit 1, so choose Tenant. Utilities Separately Metered is required on a property with more than one unit. Each unit here has its own meters, so Yes. Unit 1 has one bedroom and one full bath. The counts came in for the whole building, so enter 1 bedroom, 1 full bath, and no half baths.
Unit 1's rooms
Level and Room Detail lists the unit's levels, with the rooms on each. Unit 1 is on the ground floor. Add Level 1, above grade: 636 square feet finished, none unfinished. Add its rooms: the living room, the bedroom, then the kitchen. Kitchens and bathrooms get more detail. This kitchen was fully updated one to five years ago, and shows typical wear and tear. Then the full bath: fully updated five to ten years ago, also with typical wear and tear. Add the basement as Level B1, below grade: no finished area, and 1,270 square feet unfinished. Its utility room goes there.
Interior ratings
Interior Quality Rating uses the Q scale. With its updated kitchen and bath, the interior is a step above the exterior: Q3. Interior Condition Rating is C3: well maintained, with updated components and only normal wear. Overall Update Status for Bathrooms looks at all of the unit's baths together. Its one bath is Fully Updated.
Floors, walls and ceilings
Under Interior Features, list the flooring: hardwood, with typical wear and tear. Overall Update Status for Flooring is Significantly Updated. Walls and Ceiling is always included. The ceilings are eight feet high, and flat, and the walls and ceilings show typical wear and tear. Accessibility Features came in as None. And there are no interior defects in this unit, so Unit Interior Defects Exist is No.
Units 2 to 4
That's unit 1. Next, we'll fill in units 2, 3 and 4 the same way.